隨著機械化程度的不斷提高，鄉村改田造地、開發場所，普遍使用推土機作業，推土機作業應注意以下幾點，下面冷再生機租賃人員為您講解：

With the continuous improvement of mechanization, bulldozers are widely used in rural land conversion and development sites. The following points should be paid attention to in the operation safety of bulldozers. The following is the explanation of the cold regeneration machine rental personnel:

推土作業不能在危險的地方進行，不可強行通過泥水溝、壩埂，以防陷車，坡度大于20度的地方不能作業。

Bulldozing shall not be carried out in dangerous places. It is not allowed to forcibly pass through mud ditches and dam ridges to prevent vehicles from sinking. It is not allowed to operate in places with a slope greater than 20 degrees.

推土作業要根據土質情況，選擇適當速度，防止超負荷作業。運土?xí)r，將分配器手柄放在浮動位置，使鏟刀升降自如。

The proper speed shall be selected according to the soil quality to prevent overload operation. When transporting soil, place the distributor handle in the floating position to make the blade lift freely.

在鏟土和運土的過程中，不要轉彎，否則轉向離合器和其它零件容易損壞。盡量不要使氣缸內的活塞上升或下降到極限位置。

Do not turn during the process of shoveling and transporting soil, or the steering clutch and other parts will be easily damaged. Try not to raise or lower the piston in the cylinder to the limit position.

鏟刀切入土壤后，要根據發動機的聲音，隨時調整吃土量，防止發動機在冒黑煙的情況下作業。如發現拖拉機超負荷，應立即減少吃土量。遇有大石塊或樹根時，要用人工，切不可用推土機沖擊。

After the blade cuts into the soil, adjust the soil consumption at any time according to the sound of the engine to prevent the engine from operating under the condition of black smoke. If the tractor is found to be overloaded, reduce the soil consumption immediately. In case of large rocks or tree roots, they should be removed manually, and should not be impacted by bulldozers.

當鏟刀升起時，不要在鏟刀下觀察和修理。如需修理，應將鏟刀支撐牢靠，空行時要低速行駛。

Do not observe and repair under the blade when the blade is raised. If repair is needed, the blade should be firmly supported and driven at low speed when idling.

推土機下水作業，應事先仔細檢查行走裝置和底盤，做好防水保護。遇水部位的墊片、螺栓、螺母等，要涂上鈣基潤滑酯，再重新擰緊。機油標尺口蓋調節絲桿都要涂油以防銹蝕。

Before launching the bulldozer, carefully check the walking device and chassis in advance and do a good job of waterproof protection. Gaskets, bolts, nuts, etc. in contact with water shall be coated with calcium-based grease and then re-tightened. The adjusting screw rod of the oil scale cap shall be coated with oil to prevent corrosion.

不要長時間把推土機的分配器手柄放到“上升”或“下降”位置，以免液壓膠管爆裂。液壓膠管不要沾污燃油及酸堿物品，以防止腐蝕變質老化。

Do not put the distributor handle of the bulldozer in the "up" or "down" position for a long time to prevent the hydraulic hose from bursting. The hydraulic hose shall not be contaminated with fuel and acid-base articles to prevent corrosion, deterioration and aging.

注意，操作人員應該依地形特點及作業項目的要求，正確靈活地使用不同推土方法，提高推土機作業的工作效率。更多相關內容就來我們網站http://dzjshs.cn咨詢了解吧！

Note that the operator should use different bulldozer methods correctly and flexibly according to the terrain characteristics and the requirements of the operation project to improve the working efficiency of the bulldozer operation. Come to our website for more relevant content http://dzjshs.cn Ask about it!